It's a Jungle out there. Underground Utility Detection & Inspection Services

RCW 19.122 and Washington State Dig Laws Explained

Washington State Dig Laws

Excavation activities in Washington are primarily controlled to minimize damage to underground utilities and also for other safety reasons. Although cited as a safety and utility coordination law, RCW 19.122 actually specifies the extent to which and how a construction project—specifically, an excavation—should be performed, or even whether it should be performed at all.

Washington is no different. It provides clarity on what permissions apply, what restrictions exist, and what assistance is available, as you call before you dig in Washington.

What the Law Requires Before Ground Is Broken

A notice must be sent through the state’s one-call system before any excavation commences. This initiates a formal recordkeeping process and a response from the utility owner. The purpose of this step is to give utilities a chance to review their proposed work before any digging proceeds.

Once a notice is placed:

  • The public utility owners review the request
  • The known public utilities are located and marked within the work area.
  • Excavations should not begin until after the notice is through.

This process ensures safer planning, but not all underground infrastructure is confirmed as tagged.

What Dig Laws Do Not Cover

It is a general misconception that RCW 19.122 encompasses reference to all things under the surface. In reality, numerous entities do not necessarily fall under the mandate of public utility marking, especially on private property.

The most common are as follows:

  • Utilities are installed for a particular user only.
  • Adaptations made to specific locations.
  • Infrastructure is installed after the development and construction process.
  • Private utilities (water services, sewer services, drainage, irrigation, lighting, power, or communication to out buildings, propane, etc.).
  • Underground storage tanks

Because of these gaps, private utility-locating services in Washington State are often called in to ensure that no information is overlooked before excavations commence.

How Subsurface Data Is Collected

In situations where subsurface records and surface markings are unavailable or limited, non-destructive procedures can be used to obtain additional information. Ground-penetrating radar services in Washington use controlled signals and data collection to help in interpretation and planning with minimal disturbance to the ground.

The process typically follows these steps:

Site review and preparation:

The technician examines the available information to determine which areas to scan. Factors to consider at this stage include access conditions, the type of surface material, and any potential obstructions.

System setup and calibration:

The radar system is configured based on the known surface type and its expected depth of utility. To an individual’s preference, the settings can be adjusted to provide a clear reading of the data on the radar display.

Data collection across the surface:

It moves methodically over concrete, asphalt, or soil while signals are sent and received, and subsurface reflections are captured in real time.

Interpretation of detected responses:

Data are gathered, analyzed, and examined to infer utilities, anomalies, or other subsurface features from observed responses.

Documentation of observations:

The results documented give an unequivocal, visual representation that supports planning and decisions. The information captures site conditions at the time of scanning.

Factors That Influence What Can Be Detected

Local environmental conditions heavily influence underground finding outcomes because the reflection from subsurface elements of interest may be weak.

  • Soil type and moisture content

Different soil compositions interact with detection equipment in different ways. Moisture content alters the behavior of signals during investigation.

  • Depth and material of utilities

If utilities are placed deeper underground or built of certain materials, they may not be easily detected, particularly non-metallic ones.

  • Surface coverings and site access

Asphalt, reinforced concrete, landscaping, or other limited-access areas can reduce scanning coverage and affect data collection.

These factors account for why detection results vary and why some subsurface features emerge clearly during inspection.

Supporting Informed Dig Decisions

C-N-I Locates Ltd. provides utility locating and inspection services that give clients a clear picture of the existing underground conditions. This information streamlines the inventory process, raises awareness of many underground features, and thus enables clients to make well-informed decisions before excavation begins.

Phone Icon